Wood working

Ghetto WorkCenter Boom Arm Part IV The Tool Holder

As I was finishing up the boom arm for the Ghetto WorkCenter, it dawned on me that I could also hand a tool holder on it.

Festool includes tool holders as part of the WorkCenter. They also sell individual ones that fit on their CT vacuums. I have one of the individual ones. Unfortunately, my CT22 is too old to fit it. I have mine set into a block of wood that I clamp to my bench and BenchMark table. My ultimate plan is to use the Festool Tool Holder as a model to make a cabinet to hold all my sanders. For now, it served as a model to make a Tool Holder to fit on my Saw Tray.

This is how it began.

I began with the same piece of ½” baltic birch Ive made the rest of the Ghetto WorkCenter out of. I began by tracing the V shape of the tool holder onto the plywood. I used a forstner bit to make the rounded bottom of the V. Then I cut out the rest on the bandsaw. My bandsaw cuts weren’t exactly straight, so I used my rasp to flatten them out.

The Vs, fresh off the bandsaw.

After smoothing the sides with a rasp.

Im loving my Bosch MRC23EVSK. It has great dust collection & visibility to boot.

The cleat on the left hooks the saw tray and the spacer on the right keeps in basically plumb.

Even with the ½” plywood, it’s working great so far.

She holds like a champ.

I’m not sure if I’ll add more accessories to the Ghetto WorkCenter, but for a little bit of plywood and some cheap fasteners, it’s proving to be a great addition to the shop.

Posted by nwannabe at 6:16 PM

Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest

Labels: arm, boom, ghetto, holder, iv, part, the, tool, workcenter